问题描述:
英语翻译
1、Ssince the output is MOSFET is switching,it is difficult to isolate the switching current from the supply current at the DRAIN.An alternative is to measure the BYPASS pincurretn at 6.1v
2、BYPASS pin is not intendd for sourcing supply current to external circuitry.
3、See Typical Performance Characteristics section for BYPASS pin strat-up charging waveform.
4、For current limit at other di/dt values,refer to Figure 25.
5、This parameter is derived from characterization.
6、This parameter is derived from the change in current limit measured at 1X and 4X of the didt shown in the Ilimit specification.
7、Auto-restart on time has the same temperature characteristics as the oscillator ( inversely proportional to frequency).
1、Ssince the output is MOSFET is switching,it is difficult to isolate the switching current from the supply current at the DRAIN.An alternative is to measure the BYPASS pincurretn at 6.1v
2、BYPASS pin is not intendd for sourcing supply current to external circuitry.
3、See Typical Performance Characteristics section for BYPASS pin strat-up charging waveform.
4、For current limit at other di/dt values,refer to Figure 25.
5、This parameter is derived from characterization.
6、This parameter is derived from the change in current limit measured at 1X and 4X of the didt shown in the Ilimit specification.
7、Auto-restart on time has the same temperature characteristics as the oscillator ( inversely proportional to frequency).
问题解答:
我来补答展开全文阅读