1,single cutting processing,according to machining surface photometric requirements,pulse width is commonly 5 80us,interveinal general for pulse width 5 times,pulse width increasing can improve the processing speed,but the surface roughness increases,slowing small interveinal generally do not affect machining surface finish,can increase the processing efficiency,but too small interveinal,can make the processing is not stable,severe burn when cut molybdenum wire; For large thickness or difficult-to-machine artifacts of the workpiece generally adopted pulse width (60 - big 80us) and big interveinal (pulse width 7 to 10 times),short-circuit current 45 above,average processing current general no greater than 3.0 A.
2,processing voltage generally USES 1H,when processing large thickness workpiece and conductivity bad material to use 2H or change of the connection,the transformer higher machining voltage for machining.
3,multiple cutting generally USES three times,the first time cutting can offset generally is 0.05 0.08 mm,second offset is commonly 0.005 0.015 mm,for the last time 0mm necessary.
4,the previous ladder wave can reduce molybdenum wire losses,the general selection B,C,D gear.
再问： 有道翻译 改改吧少年 改通顺了
再答： 行稍等
再问： 继续追问 - - 有10分呐 有了都给你呐 去先吃饭去了
再答： 1, single cutting processing, according to machining surface photometric requirements, pulse width is commonly 5 ~ 80us, interveinal general for pulse width 5 times, Increasing pulse width can improve the cutting speed, but that will increase the surface roughness , smaller interveinal generally do not affect machining surface finish, and can increase the processing efficiency, but too small interveinal, can make the processing is not stable, severe burn when cut molybdenum wire; For large thickness or difficult-to-machine artifacts of the workpiece generally adopted pulse width (60 - big 80us) and big interveinal (pulse width 7 to 10 times), short-circuit current 45 above, average processing current general smaller than 3.0 A. 2, processing voltage generally USES 1H, when processing large thickness workpiece and conductivity bad material to use 2H or change of the connection, the transformer higher machining voltage for machining. 3, multiple cutting generally uses three times, the first time cutting can offset generally is 0.05 ~ 0.08 mm, second offset is commonly 0.005 ~ 0.015 mm, for the last time 0mm necessary. 4, the previous ladder wave can reduce molybdenum wire losses, the general selection B, C, D gear. 这样可以了,虽说不是很专业,但不影响阅读了
再问： 好吧追问3次 了咩
