问题描述:
英语翻译
整篇:
The proper use of Sprary gun
1.In operation,the operators need to acquire a sprary gun and was in the process of moving the angle of spraying device.In the sprary gun moving process,whether the jet transverse or longitudinal-shaped spray lotion,moving up and down,all to maintain the spray gun and work surface into a 90-degree angle,and to surface the same distance with the same speed and stability of movement,or painting may be uneven.
2.Have a good knowledge of spray gun moving speed.Paint spray gun movement speed and extent of drying,ambient temperature,the viscosity of the coating.Row speed is 0.3m\s.If moving too fast,it can make rough matte film and film leveling poor;Move too slow,it will occur after the film tears.So the speed must be consistent,otherwise uneven film thickness.
3.Master spray routes and methods.The method of using spray gun is longitudinal overlap,overlapping,vertical and horizontal transverse alternating spray.Coating line must be high to low,from left to right,top to bottom,first in the outer order.Trip should be planned to move gun steady,one-way trip in the end arrived when wrenched open armed,and then pulling pulling armed,began to spray the opposite direction based upon the same route.
This carried over:http://www.zgxinwei.com/ reproduced please specify,thank you!
急,万分感谢各路英语高手.
整篇:
The proper use of Sprary gun
1.In operation,the operators need to acquire a sprary gun and was in the process of moving the angle of spraying device.In the sprary gun moving process,whether the jet transverse or longitudinal-shaped spray lotion,moving up and down,all to maintain the spray gun and work surface into a 90-degree angle,and to surface the same distance with the same speed and stability of movement,or painting may be uneven.
2.Have a good knowledge of spray gun moving speed.Paint spray gun movement speed and extent of drying,ambient temperature,the viscosity of the coating.Row speed is 0.3m\s.If moving too fast,it can make rough matte film and film leveling poor;Move too slow,it will occur after the film tears.So the speed must be consistent,otherwise uneven film thickness.
3.Master spray routes and methods.The method of using spray gun is longitudinal overlap,overlapping,vertical and horizontal transverse alternating spray.Coating line must be high to low,from left to right,top to bottom,first in the outer order.Trip should be planned to move gun steady,one-way trip in the end arrived when wrenched open armed,and then pulling pulling armed,began to spray the opposite direction based upon the same route.
This carried over:http://www.zgxinwei.com/ reproduced please specify,thank you!
急,万分感谢各路英语高手.
问题解答:
我来补答展开全文阅读