问题描述:
英语翻译
INSTRUCTIONS MANUAL
BATTERY TESTER 12-V -160 Ah max
Model :BI-300
---Voltmeter( 0 to 16V )
---Starter capacity
----Load circuit (alternator)
Important :This tester is provided of a sound buzzer ,which will start after 15 seconds of test .
As soon as the ringing resounds ,it is necessary to read quickly the results posted on the voltmeter and immediately give to zero the needle of the “DC-AMPS” while unscrewing the central button by several turns towards “OFF”
A/BATTERY TEST
The battery must be tested when it is at “rest “.
If the tension is >12.6V or if it was used less than 15 minutes before the test,it is advisable to bring back it to ist tension “test “.
2 possibilities:
---Lighe the headlights of the car during 5 seconds .
---Use BI-300 TO 150A during 15 seconds ( scale black of monitor “DC-AMPS” )
Then leave the battery at rest during 10 minutes so that it is stabilized .
Test of tension
----Turn the button of BI-300 to several turns towards the left “OFF “ until the needle of monitor “ DC-AMPS “ is to 0.
---Put the red clamp at (+) of the battery .
----Put the black clamp at (-) of the battery.
If the needle of the voltmeter (monitor DC Volts) shows less that 12.4V,the battery must be reloaded and retested .If ,after the new test ,the battery is
INSTRUCTIONS MANUAL
BATTERY TESTER 12-V -160 Ah max
Model :BI-300
---Voltmeter( 0 to 16V )
---Starter capacity
----Load circuit (alternator)
Important :This tester is provided of a sound buzzer ,which will start after 15 seconds of test .
As soon as the ringing resounds ,it is necessary to read quickly the results posted on the voltmeter and immediately give to zero the needle of the “DC-AMPS” while unscrewing the central button by several turns towards “OFF”
A/BATTERY TEST
The battery must be tested when it is at “rest “.
If the tension is >12.6V or if it was used less than 15 minutes before the test,it is advisable to bring back it to ist tension “test “.
2 possibilities:
---Lighe the headlights of the car during 5 seconds .
---Use BI-300 TO 150A during 15 seconds ( scale black of monitor “DC-AMPS” )
Then leave the battery at rest during 10 minutes so that it is stabilized .
Test of tension
----Turn the button of BI-300 to several turns towards the left “OFF “ until the needle of monitor “ DC-AMPS “ is to 0.
---Put the red clamp at (+) of the battery .
----Put the black clamp at (-) of the battery.
If the needle of the voltmeter (monitor DC Volts) shows less that 12.4V,the battery must be reloaded and retested .If ,after the new test ,the battery is
问题解答:
我来补答展开全文阅读